Sand dunes are formed due to the earth’s erosional and depositional forces. Dune sand being collapsible and due to lose formation, is not suitable to be used as subgrade material for pavements or any other infrastructure applications as its sand grains contain large voids in between which results in its poor gradation and inability of being compacted. The prime objective of this research paper is to estimate the feasibility of using and converting dune sand into sustainable fill material and improving its engineering characteristics as well as its gradation using pozzolanic cement supplementary wastes in optimum proportion. To achieve this objective three types of pozzolanic wastes viz. Wheat straw ash (WSA), Fluid catalytic cracking catalyst residue (FC3R), Nano silica (NS) were used replacing cement partially in proportion of 2%, 3%, 4% and 5% respectively aggregating total additives (waste + cement) as 8%, 10%, 12% and 14%. The engineering parameters MDD, OMC, UCS and CBR are mainly evaluated from this study. From the results and analysis, it is observed that partial replacement of 2% WSA, 14%FC3R and 3%NS showed the maximum improvement in UCS values. Further the results obtained for various percentage of dosages were compared with recommendations given by IRC for cement stabilization.
Published in | Journal of Civil, Construction and Environmental Engineering (Volume 7, Issue 6) |
DOI | 10.11648/j.jccee.20220706.13 |
Page(s) | 118-124 |
Creative Commons |
This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited. |
Copyright |
Copyright © The Author(s), 2022. Published by Science Publishing Group |
Dune Sand, Stabilization, Sustainable, Unconfined Compressive Strength, Pozzolanic Reaction, Pozzolanic Wastes
[1] | Abbas J. Al-taie, Yousif J. Al-shakarchi Ali A. Mohammed. (2017). “Investigation of geotechnical specifications of sand dune soil.” IIUM Engineering Journal, Volume 14 (2), pp. 121-132. |
[2] | AwadAlKarni and Sherif M. ElKholy. (2018). “Improving Geotechnical Properties of Dune Sands through Cement Stabilization.” Journal of Engineering and Computer Sciences, Volume 5, pp. 1-19. |
[3] | Mohammad Ali Pashabavandpouri, SajadJahangiri. (2020). “Effect of Nano silica on compaction and strength properties of clayey soil stabilized with lime.” Journal of Applied Environmental and Biological Sciences, Volume 5, pp. 538-548. |
[4] | Zainab S. Al-khafaji, Zainab Al Masoodiet al. (2021). “The effect of using fluid catalytic cracking catalyst residue (fc3r) as a cement replacement in soft soil stabilization.” International Journal of Civil Engineering and Technology, Volume 9, pp. 522-533. |
[5] | Vikas Sharma, Pramod Kumar Rathore and Amit Sharma. (2018). “Influence of the Wheat Straw Ash and Lime on Engineering Properties of Clayey Sub-grade.” Journal of Civil Engineering and Environmental Technology, Volume 5, pp. 31-38. |
[6] | IRC 37 (2018) (6): Guidelines for the design of flexible pavements. |
[7] | IRC SP: 89 (2018) (28): Guidelines for the design of stabilized pavements. |
[8] | Aiban A. Study of sand stabilization in Eastern Saudi Arabia. Journal of Engineering Geology, 1994, 38, No. 1–2, 65–79. |
[9] | Baghdadi Z. A. And Rahman M. A. The potential of cement kiln dust for the stabilization of dune sand in highway construction. Building and Environment, 2000, 25, No. 4, 285–289. |
[10] | Ali G. A. And Youssef A. F. Stabilization of silt: a case study for low-volume roads in Saudi Arabia. Transportation Research Record, 2002, No. 898, 283–290. |
[11] | O’sadnick D. L., Simpson B. E. And Kasel G. K. Evaluation and performance of a sand/bentonite liner. Proceedings of Geoenvironment 2000, ASCE, New Orleans, LA, 2005, 688–701. |
[12] | Wahab H. I. A. And Asi I. M. Improvement of marl and dune sand for highway construction in arid areas. Journal of Building and Environment, 2010, 32, No. 3, 271–279. |
[13] | Taha R. A. And Pradeep M. R. Use of fly ash-stabilized sand mixtures as capping materials for landfills. Proceedings of the 1997 Symposium on Testing Soil with Waste or Recycled Materials, New Orleans, LA, 2014, 172– 180. |
[14] | Turner J. P. Evaluation of Western coal fly ashes for stabilization of low-volume roads. Proceedings of the 1997 Symposium on Testing Soil with Waste or Recycled Materials, New Orleans, LA, 2016, 157–171. |
[15] | Consoli N. C., Prietto P. D. M., Carraro J. A. H. And Heineck K. S. Behavior of compacted soil–fly ash–carbide lime mixtures. Journal of Geotechnical and Geoenvironmental Engineering, ASCE, 2017, 127, No. 9, 774–782. |
[16] | Al-Khanbashi A., Mohamed A. M. O., Moet A. And Hadi B. Stabilization of desert sand using water-born polymers. Proceedings of the 1st International Conference on Geotechnical, Geoenvironmental Engineering and Management in Arid Lands, Al-Ain, 2018, 143–148. |
[17] | Kaniraj S. R. And Havanagi V. G. Behavior of cementstabilized fiber-reinforced fly ash–soil mixtures. Journal of Geotechnical and Geoenvironmental Engineering, ASCE, 2019, 127, No. 7, 574–584. |
[18] | Ali G. A., Al-Aghbari M. And Al-Jahadhamy A. Evaluation of stabilized base, sand seal, and slurry seal pavement sections. Proceedings of the 1st International Conference on Geotechnical, Geoenvironmental Engineering and Management in Arid Lands, Al-Ain, 2020, 165–173. |
[19] | Jones, G., 1997. Analysis of beams an elastic foundation. Thomas Telford, United Kingdom. |
[20] | Moayed, R. Z., and M. Janbaz. 2009. Effective parameters on modulus of subgrade reaction in clayey soils. J. Applied Sci., 9: 4006-4012. |
[21] | Schmertmann, J. H. (1970). “Static cone to compute static settlement over sand.” J. Soil Mech. Found. Div., ASCE, 96 (3), 1011-1043. |
[22] | AASHTO. 2003. Guidelines for pavement design, Virginia DoT-Materials Division Pavement Design And Evaluation Section, Revised – May 2003. |
[23] | Powell, W. D., Potter, J. F., Mayhew, H. C., and Nunn, M. E. 1984. The structural design of bituminous roads. TRRL Report LR 1132, 62 pp. |
[24] | Hetenyi, M. 1946. Beams on elastic foundation. University of Michigan Press, Ann Arbor. |
[25] | Kameswara Rao, N. S. V. 2000. Dynamic soil tests and applications. A. H. Wheeler & Co. Ltd, New Delhi, First Edition. |
[26] | Timoshenko, S., and Goodier, J. N. 1951. Theory of Elasticity. Mc Graw-Hill, Book Company Inc, New York, US. |
[27] | Harr, M. E. 1966. Foundations of theoretical soil mechanics. McGraw-Hill, New York. |
APA Style
Sandipkumar Kori, Manish Shah. (2022). Assessment of Pozzolanic Reaction and Resulting Strength of Dune Sand Stabilized with Cement Supplementary Pozzolanic Waste Materials. Journal of Civil, Construction and Environmental Engineering, 7(6), 118-124. https://doi.org/10.11648/j.jccee.20220706.13
ACS Style
Sandipkumar Kori; Manish Shah. Assessment of Pozzolanic Reaction and Resulting Strength of Dune Sand Stabilized with Cement Supplementary Pozzolanic Waste Materials. J. Civ. Constr. Environ. Eng. 2022, 7(6), 118-124. doi: 10.11648/j.jccee.20220706.13
@article{10.11648/j.jccee.20220706.13, author = {Sandipkumar Kori and Manish Shah}, title = {Assessment of Pozzolanic Reaction and Resulting Strength of Dune Sand Stabilized with Cement Supplementary Pozzolanic Waste Materials}, journal = {Journal of Civil, Construction and Environmental Engineering}, volume = {7}, number = {6}, pages = {118-124}, doi = {10.11648/j.jccee.20220706.13}, url = {https://doi.org/10.11648/j.jccee.20220706.13}, eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.jccee.20220706.13}, abstract = {Sand dunes are formed due to the earth’s erosional and depositional forces. Dune sand being collapsible and due to lose formation, is not suitable to be used as subgrade material for pavements or any other infrastructure applications as its sand grains contain large voids in between which results in its poor gradation and inability of being compacted. The prime objective of this research paper is to estimate the feasibility of using and converting dune sand into sustainable fill material and improving its engineering characteristics as well as its gradation using pozzolanic cement supplementary wastes in optimum proportion. To achieve this objective three types of pozzolanic wastes viz. Wheat straw ash (WSA), Fluid catalytic cracking catalyst residue (FC3R), Nano silica (NS) were used replacing cement partially in proportion of 2%, 3%, 4% and 5% respectively aggregating total additives (waste + cement) as 8%, 10%, 12% and 14%. The engineering parameters MDD, OMC, UCS and CBR are mainly evaluated from this study. From the results and analysis, it is observed that partial replacement of 2% WSA, 14%FC3R and 3%NS showed the maximum improvement in UCS values. Further the results obtained for various percentage of dosages were compared with recommendations given by IRC for cement stabilization.}, year = {2022} }
TY - JOUR T1 - Assessment of Pozzolanic Reaction and Resulting Strength of Dune Sand Stabilized with Cement Supplementary Pozzolanic Waste Materials AU - Sandipkumar Kori AU - Manish Shah Y1 - 2022/12/29 PY - 2022 N1 - https://doi.org/10.11648/j.jccee.20220706.13 DO - 10.11648/j.jccee.20220706.13 T2 - Journal of Civil, Construction and Environmental Engineering JF - Journal of Civil, Construction and Environmental Engineering JO - Journal of Civil, Construction and Environmental Engineering SP - 118 EP - 124 PB - Science Publishing Group SN - 2637-3890 UR - https://doi.org/10.11648/j.jccee.20220706.13 AB - Sand dunes are formed due to the earth’s erosional and depositional forces. Dune sand being collapsible and due to lose formation, is not suitable to be used as subgrade material for pavements or any other infrastructure applications as its sand grains contain large voids in between which results in its poor gradation and inability of being compacted. The prime objective of this research paper is to estimate the feasibility of using and converting dune sand into sustainable fill material and improving its engineering characteristics as well as its gradation using pozzolanic cement supplementary wastes in optimum proportion. To achieve this objective three types of pozzolanic wastes viz. Wheat straw ash (WSA), Fluid catalytic cracking catalyst residue (FC3R), Nano silica (NS) were used replacing cement partially in proportion of 2%, 3%, 4% and 5% respectively aggregating total additives (waste + cement) as 8%, 10%, 12% and 14%. The engineering parameters MDD, OMC, UCS and CBR are mainly evaluated from this study. From the results and analysis, it is observed that partial replacement of 2% WSA, 14%FC3R and 3%NS showed the maximum improvement in UCS values. Further the results obtained for various percentage of dosages were compared with recommendations given by IRC for cement stabilization. VL - 7 IS - 6 ER -