Home / Journals International Journal of Mechanical Engineering and Applications / Electrofusion Joint Design Within Better Efficiency
Electrofusion Joint Design Within Better Efficiency
Submission DeadlineMar. 30, 2020

Submission Guidelines: http://www.sciencepublishinggroup.org/home/submission

Lead Guest Editor
Aref Rajabi
Department of Inspection, Mazandaran Gas Company, Sari, Iran
Guest Editors
  • Javad Alinejad
    Department of Mechanical Engineering, Azad University, Sari, Iran
  • Keivan Fallah
    Department of Mechanical Engineering, Azad University, Sari, Iran
  • Davood Domiri Ganji
    Department of Mechanical Engineering, Babol Nooshirvani University of Technology, Babol, Iran
  • Reza Najafi Esfandooni
    Department of Hse, Mazandaran Gas Company, Sari, Iran
  • Hamzeh Ahmadi
    Department of ICT, Mazandaran Gas Company, Sari, Iran
  • Peyman Eskandarpour
    Department of Research and Development, Mazandaran Gas Company, Sari, Iran
Non-metallic pipes and fittings are very important in industrial piping, so much research is required in this field. One of the usual types of these joints is electrofusion joint. In different aspects , Investigation of these joints is affected on the quality of welding, time of welding and pipelines cost. Our special issue topics related to electrofusion joint are as follows:
  1. Wires effect: Number of wires; location, size and properties of wires; ratio of wire thermal conductivity to polyethylene(PE) thermal conductivity
  2. The volume, mass and geometrical characteristics of joint on welding quality
  3. PE melting and freezing process simulation
  4. Heating, cooling and temperature distribution in welding process simulation
  5. Effects of joint expansion, contraction and temperature distribution simulation
  6. Effects of temperature and earth different climate conditions in joint welding
  7. Effects of wire's electrical and mechanical properties changes in melting and freezing process
  8. Various methods of PE joints production and reducing fixed cost and time
  9. The effect of changing the applied voltage and amperage in the joints
  10. Investigating the effect of various non-dimensional numbers (such as Nusselt, Reynolds, Stephen) on the joints thermal behavior
  11. Simulation and investigation different types of joints such as: Coupler, Transducer, Saddle, Tee, Knee , …
  12. Two and three-dimensional simulation and investigation of above mentioned cases
All experimental, laboratory and numerical articles on this issue and articles submitted by electrofusion joint manufacturers are acceptable.
Aims and Scope:
  1. Polyethylene, Electrofusion Joints
  2. Welding, Temperature Distribution
  3. Melting And Freezing
  4. Joints Thermal Behavior, Production Various Methods
  5. Reducing fixed cost
  6. Joint expansion and contraction
Guidelines for Submission
Manuscripts should be formatted according to the guidelines for authors
(see: http://www.sciencepublishinggroup.org/journal/guideforauthors?journalid=220).

Please download the template to format your manuscript.

Science Publishing Group
1 Rockefeller Plaza,
10th and 11th Floors,
New York, NY 10020
Tel: (001)347-983-5186