This paper proposes a mathematical modelling of DC-DC boost converter-inverter system and simulation work is carried out using Scilab/Xcos, which is free and open-source software. In this paper a two-stage DC-AC power conversion system is presented. This system consists of two converters, DC-DC boost converter and single-phase inverter. The boost converter converts input DC low voltage into high DC output voltage. The DC output from boost converter is converted into AC output voltage by an inverter. The mathematical model of a DC-AC boost converter-inverter system is presented with four different modes of operations. By using Kirchhoff’s voltage and current law, the system mathematical model is derived from each operation mode. The mathematical model of the proposed system is represented and state-space matrix is derived. Moreover, the steady-state values of the system are also presented. The transient behaviors of the proposed mathematical model are validated with Xcos simulation results.
| Published in | Software Engineering (Volume 6, Issue 2) |
| DOI | 10.11648/j.se.20180602.11 |
| Page(s) | 27-36 |
| Creative Commons |
This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited. |
| Copyright |
Copyright © The Author(s), 2018. Published by Science Publishing Group |
DC-DC Boost Converter, Free and Open-Source, Mathematical Model, Simulation, Single-Phase Inverter
| [1] | R. W. Erickson amd D. Maksimovic, “Fundamental of Power Electronics”, Second Edition. |
| [2] | Victor Hugo Garcia-Rodriguez, Ramon Silva-Ortigoza, Eduardo Hernandez-Marquez, Jose Rafael Garcia-Sanchez, Mario Ponce-Silva and Griselda Saldana-Gonzalez, “A DC Motor Driven by a DC-DC Boost Converter-Inverter: Modeling and Simulation”, 2016 International Conference on Mechatronics and Automotive Engineering (ICMEAE), DOI: 10. 1109/ ICMEAE. 2016. 023. |
| [3] | H. Abdel-Gawad and V. K. Sood, “Small-Signal Analysis of Boost Converter, including Parasitic, operating in CCM”, 2014 6th IEEE Power India International Conference (PIICON), DOI: 10. 1109/POWERI. 2014. 7117622. |
| [4] | Gokhan Altintas, Mehmet Onur Gulbahce and Derya Ahmet Kocabas, “Nonideal Analysis, Design and Voltage Mode Control of a Boost Converter”, Power and Electrical Engineeringof Riga Technical University (RTUCON), 57th International Scientific Conference, 2016, DOI: 10. 1109/ RTUCON. 2016. 7763137. |
| [5] | Chien-Husan Chang, Chun-A Cheng, Chu-Cheng Chi and Yen-Yu Chen, “Design and Implementation of a Single-Phase Buck-Boost Inverter”, 2017 IEEE 3rd International Future Energy Electronics Conference and ECCE Asia (IFEEC 2017 - ECCE Asia), DOI: 10. 1109/IFEEC. 2017. 7992252. |
| [6] | Tiantian Mu, Lei Zhu, Hongfei Wu, Wenying Jiang, “A Semi-Two-Stage DC-AC Power Conversion System with Improved Efficiency Based on A Dual-input Inverter”, 2016 IEEE Energy Conversion Congress and Exposition (ECCE), DOI: 10. 1109/ ECCE. 2016. 7854773. |
| [7] | C. I. Odeh, “Single Phase DC-AC Boost Converter”, Nigerian Journal of Technology (NIJOTECH), Vol. 33. No. 2, April 2014. pp. 238-244, doi. org: 10. 4314/njt. v33i2. 14. |
| [8] | Dong-Yub Hyun, Chang-Soon Lim, Rae-Young Kim, Dong-Seok Hyun, “Averaged Modeling and Control of a Single-Phase Grid-Connected Two-Stage Inverter for Battery Application”, IECON 2013 - 39th Annual Conference of the IEEE Industrial Electronics Society, DOI: 10. 1109/IECON. 2013. 6699184. |
| [9] | Manish Agarwal, Sanjeev Gupta, Sudhir P. Phulambrikar, “Closed Loop DC-DC Boost Converter with Inverter for Small Scale Generation Plant”, International Journal of Engineering Trends and Technology (IJETT) – Volume 15 Number 5 – Sep 2014. |
| [10] | Scilab: Free and Open source Software, http://www.scilab.org/ |
| [11] | Lijun Wang, Qing Li, Chaonan Tong, Yixin Yin, Jiangyun Li and Siyang Song, "Active Disturbance Rejection Control simulation toolbox in open source software Scilab/Xcos," Open-source software for Scientific Computation (OSSC), 2011 IEEE International Workshop, Beijing, China, pp. 71-76, DOI:10. 1109/OSSC. 2011. 6184697. |
| [12] | Zoltan Janik and Katarina Zakova, "Online design of Matlab/Simulink and Scilab/Xcos block schemes," Interactive Collaborative Learning (ICL), 2011 14th International Conference, Slovakia, pp. 241-247, DOI: 10. 1109/ICL. 2011. 6059583. |
| [13] | Haofu Liao, Ping Chen, "Explore a Way of Improving the Computational Efficiency of the Block in SCILAB," Open-source software for Scientific Computation (OSSC), 2011 IEEE International Workshop, Beijing, China, pp. 13-16, DOI:10. 1109/OSC. 2011. 6184686. |
| [14] | Vijay Babu Koreboina and Shankar J Magajikondi, Raju A B, “Scilab/ Xcos Modeling, Simulation and PC Based Implementation of Closed Loop Speed Control of VSI Fed Induction Motor Drive”, 16th National Power Systems Conference, 15th-17thDecember, 2010. |
| [15] | Vinod S. Patil, Sachin Angadi and A. B. Raju, "Four Quadrant Close Loop Speed Control of DC Motor," Circuits, Controls, Communications and Computing (I4C), 2016 International Conference, India, DOI:10. 1109/CIMCA. 2016. 8053305. |
| [16] | B. M Hasaneen and Adel A. Elbaset Mohammed, “Design and Simulation of Dc/Dc Boost Converter”. 12th International Middle-East Power System Cpnference, 2008, DOI: 10. 1109/MEPCON. 2008. 4562340 |
APA Style
Thandar Aung, Tun Lin Naing. (2018). Modeling and Simulation of DC-DC Boost Converter-Inverter System with Open-Source Software Scilab/Xcos. Software Engineering, 6(2), 27-36. https://doi.org/10.11648/j.se.20180602.11
ACS Style
Thandar Aung; Tun Lin Naing. Modeling and Simulation of DC-DC Boost Converter-Inverter System with Open-Source Software Scilab/Xcos. Softw. Eng. 2018, 6(2), 27-36. doi: 10.11648/j.se.20180602.11
Share This Article
Twitter
Linked In
Facebook
Copy
Download@article{10.11648/j.se.20180602.11,
author = {Thandar Aung and Tun Lin Naing},
title = {Modeling and Simulation of DC-DC Boost Converter-Inverter System with Open-Source Software Scilab/Xcos},
journal = {Software Engineering},
volume = {6},
number = {2},
pages = {27-36},
doi = {10.11648/j.se.20180602.11},
url = {https://doi.org/10.11648/j.se.20180602.11},
eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.se.20180602.11},
abstract = {This paper proposes a mathematical modelling of DC-DC boost converter-inverter system and simulation work is carried out using Scilab/Xcos, which is free and open-source software. In this paper a two-stage DC-AC power conversion system is presented. This system consists of two converters, DC-DC boost converter and single-phase inverter. The boost converter converts input DC low voltage into high DC output voltage. The DC output from boost converter is converted into AC output voltage by an inverter. The mathematical model of a DC-AC boost converter-inverter system is presented with four different modes of operations. By using Kirchhoff’s voltage and current law, the system mathematical model is derived from each operation mode. The mathematical model of the proposed system is represented and state-space matrix is derived. Moreover, the steady-state values of the system are also presented. The transient behaviors of the proposed mathematical model are validated with Xcos simulation results.},
year = {2018}
}
TY - JOUR T1 - Modeling and Simulation of DC-DC Boost Converter-Inverter System with Open-Source Software Scilab/Xcos AU - Thandar Aung AU - Tun Lin Naing Y1 - 2018/07/31 PY - 2018 N1 - https://doi.org/10.11648/j.se.20180602.11 DO - 10.11648/j.se.20180602.11 T2 - Software Engineering JF - Software Engineering JO - Software Engineering SP - 27 EP - 36 PB - Science Publishing Group SN - 2376-8037 UR - https://doi.org/10.11648/j.se.20180602.11 AB - This paper proposes a mathematical modelling of DC-DC boost converter-inverter system and simulation work is carried out using Scilab/Xcos, which is free and open-source software. In this paper a two-stage DC-AC power conversion system is presented. This system consists of two converters, DC-DC boost converter and single-phase inverter. The boost converter converts input DC low voltage into high DC output voltage. The DC output from boost converter is converted into AC output voltage by an inverter. The mathematical model of a DC-AC boost converter-inverter system is presented with four different modes of operations. By using Kirchhoff’s voltage and current law, the system mathematical model is derived from each operation mode. The mathematical model of the proposed system is represented and state-space matrix is derived. Moreover, the steady-state values of the system are also presented. The transient behaviors of the proposed mathematical model are validated with Xcos simulation results. VL - 6 IS - 2 ER -
Information
Email: